flathead lifters pitted
#1
flathead lifters pitted
I just started tearing down my 52 V8 , it looks like it was a real oil burner , most of the valves were not sealing good and oil/sludge was knee deep under the intake manifold . I got the valve assemblies all out , good fun there! And then when I pulled out the lifters 4 of them were badly pitted from the top to were they come up to open the valve . I didn't see any water in there to rust them ,they look clean but pitted . What could cause this? Is it something to worry about? Some of the valve guide were worn , I could wiggle the valves a bit. Engine was never stuck like most are ,turned over ok, just some of the vaves were stuck ,PB blaster ,time and a rubber hammer loosen them up fine. tony
Thread
Thread Starter
Forum
Replies
Last Post
Fords&Farmalls
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
27
04-11-2022 09:26 PM
MattMac
335 Series- 5.8/351M, 6.6/400, 351 Cleveland
12
07-10-2017 03:12 PM
C_thetroll
1967 - 1972 F-100 & Larger F-Series Trucks
26
08-18-2016 04:49 PM