Bellhousing fitment and my new project. Pictures
#1
Bellhousing fitment and my new project. Pictures
Hey all, will the bellhouseing from a "3-std light duty" from a '56 f-100 bolt up exactly to a T-86? It is bolting up to a 223 I-6.
[img][/img]
[img][/img]
Picked it up in Turlock California earlier today. I am expecting certain things to go wrong...but I am still happy. I thought the bellhousing came with it, but apparently not. Once again, I'll deal with issues as I come across them, but until then, I just gotta get the truck started and on it's way back on the road.
there also appears to be no place to mount the clutch type thing.....hmmmm
I doubt I'll have a chance to even start planning it's installation within the next 3-4 months.
[img][/img]
[img][/img]
Picked it up in Turlock California earlier today. I am expecting certain things to go wrong...but I am still happy. I thought the bellhousing came with it, but apparently not. Once again, I'll deal with issues as I come across them, but until then, I just gotta get the truck started and on it's way back on the road.
there also appears to be no place to mount the clutch type thing.....hmmmm
I doubt I'll have a chance to even start planning it's installation within the next 3-4 months.
#2
#3
#4
I will measure the input shaft. I think it is the same length as the trans I have installed now.
Yes, I know it's an OD.....that's why I bought it. Don't you remember my ridiculous thread about OD t-86's I made a few months back?
Thanks a lot, you guys.
Thread
Thread Starter
Forum
Replies
Last Post
RUN4CVR
1957 - 1960 F100 & Larger F-Series Trucks
13
07-22-2014 08:34 PM