thinking about a mod day
#1
thinking about a mod day
I am thinking about having a little mod day / barbue and beer if anyone is interested...
I have a gauge pod and gauges here,and just ordered a intake,exhaust,and dp tuner from riffraff.Being a newb to this truck if some of you that have the knowledge and would like to help me install this stuff i would love to meet some of you and get some things installed..
I will also have a few guys from the car club here to oversee and drink,eat and help out.
please let me know if anyone is interested and ill set a date
I have a gauge pod and gauges here,and just ordered a intake,exhaust,and dp tuner from riffraff.Being a newb to this truck if some of you that have the knowledge and would like to help me install this stuff i would love to meet some of you and get some things installed..
I will also have a few guys from the car club here to oversee and drink,eat and help out.
please let me know if anyone is interested and ill set a date
#3
Let me know when and I will see if I can stop by
#5
#6
I wouldn't bother shimming until you know what you fuel pressure is to begin with, IMO.
#7
Properly done, a pressure gauge should be used before and after. On the other hand, I'm not the Powerstroke guru. If it was a DT360/466(International), then I'd be on it.
Thread
Thread Starter
Forum
Replies
Last Post
haulingboat
1999 - 2003 7.3L Power Stroke Diesel
31
01-19-2008 05:21 AM