PCV and Custom Valve Cover

Reply Subscribe

Thread Tools

Search this Thread

09-28-2009, 08:37 PM

Hillcapper

Senior User

Thread Starter

Join Date: Jan 2008

Location: Mooresville, NC

Posts: 196

Likes: 0

Received 0 Likes on 0 Posts

PCV and Custom Valve Cover

Drilled my custom cast aluminum cover for the PCV grommet. Custom cover has no baffle setup on the underside for the PCV. Is this going to be a problem? If so what is the solution

Thanks,
Craig

Reply Like

09-29-2009, 03:48 AM

lew52

Postmaster

Join Date: Jan 2009

Posts: 4,558

Likes: 0

Received 1 Like on 1 Post

I drilled my valve cover for the pcv the same way you did , have not had any problems.. Lew

Reply Like

09-29-2009, 07:55 AM

Hillcapper

Senior User

Thread Starter

Join Date: Jan 2008

Location: Mooresville, NC

Posts: 196

Likes: 0

Received 0 Likes on 0 Posts

Lew,
So you have no baffle either? I was just concerned that there will be a lot of oil splashing around and getting up in the system.

Thanks

Reply Like

Reply Subscribe

Related Topics

Thread

Thread Starter

Forum

Replies

Last Post

Size for matter... While it fit?

Moe Craig

1948 - 1956 F1, F100 & Larger F-Series Trucks

09-28-2015 10:38 PM

5.4L 3V Valve Cover/PCV

CurtSD

Modular V8 (4.6L, 5.4L)

08-26-2014 04:17 PM

PCV valve change, without removing the cover?

Gage2502

Modular V10 (6.8l)

03-28-2014 04:33 PM

Tailgate question?

1986F150six

1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks

03-28-2014 01:02 PM

Where to get PCV gromment for 352 vavle cover....

usa5913

1961 - 1966 F-100 & Larger F-Series Trucks

02-14-2011 01:43 AM