Archived NM Buy/Sell/Trade Ads

[KRDiesel]

Edge juce with attatude for 6.0 diesel. Works great!! $400 Version 4.0 this is the latest version.

[KRDiesel]

SCT Livewire, 4 resets left. Will include one Spartin tune of your choice. $525 obo

[IB Tim]

1991 Thunderbird Super Coupe, 32K original miles, White all original, gray leather interior...I special ordered this car, it has EVERY option except the moon roof.

The back seats have never even been sat in, garaged its entire life, never been driven in the rain....Always in the Southwest dry climate.

A 91 with only 31k miles has got to be a bit rare, I am not getting rid of it cheap....so please only serious inquires only.

[reeves_mck]

Need borg warner t18 tranny

[biz4two]

Selling 1976 F150 4x4 (see sig) rear 3" wide leaf springs with an add-a-leaf. The springs are about 6 yrs old, but were only on the truck for about a 6 months until I decided to install Skyjacker 2" replacement springs. Now time to clean out garage.

The nice thing...if you need stock spring setup...just remove the add-a-leaf.

$100.00 for the pair. Check you application but '73-'79 should fit.

Thanks.

biz

[BChance]

Edelbrock Performer 1405. 600 cfm. Manual choke. (no cable, can't find it..) Cast finish. Good for a smaller stock motor, or mild cam. Have a banjo fuel inlet and adapter plate for spread bore, if you need either or both. Jetted for 7500+ altitude, but I have jets and rods to re-tweak it. Tell me what you want, we can set it up. Used for about 6 months, then I re-cammed and did the heads on the motor it was on, and it just wasn't enough on the top end anymore, went to a 750.

$150.00

send me a PM or email me if your interested.

[RDJ184]

Originally Posted by BChance

Edelbrock Performer 1405. 600 cfm. Manual choke. (no cable, can't find it..) Cast finish. Good for a smaller stock motor, or mild cam. Have a banjo fuel inlet and adapter plate for spread bore, if you need either or both. Jetted for 7500+ altitude, but I have jets and rods to re-tweak it. Tell me what you want, we can set it up. Used for about 6 months, then I re-cammed and did the heads on the motor it was on, and it just wasn't enough on the top end anymore, went to a 750.

$150.00

send me a PM or email me if your interested.

its a chevy!!!!

[BChance]

Yea...it is. Went into my sons Z28. Have I mentioned how much I hate that car? Or how much that car hates me?

[KRDiesel]

Yea, but at least you have a ford to pull the chevy

[jaynalbu]

I would like to find a tailgate, camper shell and a really good deal on a spray in liner.
Please contact me if you have any of these
Thanks
Jason

[beartracks]

Items for sale, some free to a good home. Mostly 1977 F100/400/C6. "E"mail for more info. You will have to come and get the parts. I'm too lazy to package and ship.

Engine:

1. Original 2V manifold and like new EGR plate.
2. 2V Heads
3. Lots of stock AC parts and brackets.
4. Various Holley carbs and parts.
5. Electric fuel pump, regulators.
6. Mallary unilite, factory reconditioned/unused.
7. Mallory Comp 9000 unilite factory reconditioned/unused.
8. Caps, rotors, modules etc for above.
9. Accel timing computer system. Works with various ignitions.
10. Various length pushrods, guide plates.
11. Brackets, air pumps etc, etc.

Tranny:

1. C6 tail shaft.
2. Two converters, one RV one light stall.


Body:
1. Bumper mount trailer hitch (from 71 LTD)
2. Original muffler heat shield.
3. Hood hinges with springs
4. Hood springs.
5. Pig iron rear bumper.
6. “I” beams
7. Front coil springs.
8. Braided steel brake line for 4X4 (new).

Other:

1. CB radios (2)
2. Electric antennae (Ford)


Tools:

1. Engine stand, 4 wheels, never used.
2. Engine stand for motorcycle, bolt down, plate for older 4cyl Hondas.
3. Toe in and camber gauges, as new.
4. Drill bit sharpener, Sears.

Take in trade?:

1. Race track trim.
2. Old beer signs and clocks.
3. Old radios.

[jaynalbu]

1. CB radios (2)
Do you still have this? Is it one of the freebies or how much do you need for it?
Thanks
Jason

[BChance]

Looking for the underneath spare mounting hardware for my 93 F350 4X4.. anybody got parts?

Put the camper on, nowhere to put the spare but up on the top, and that is way up there to lug a heavy tire and wheel...not to mention I don't want to do that to the roof.

[KRDiesel]

Craftsman pressure washer, 3 years old, but only about 4 hours use.
6.75 HP OHV B&S intec
2500PSI 2.5gpm
Model 580767450
4 soap holders.
$275 OBO

[KRDiesel]

Originally Posted by KRDiesel

Edge juce with attatude for 6.0 diesel. Works great!! $400
Version 4.0 this is the latest version.

Going down to $350. This will work on a 03 to 07 6.0.