Help...TPS screw broke off. Do I use heat?
#1
Help...TPS screw broke off. Do I use heat?
Any suggestions will be greatly appreciated.
While replacing the original throttle position sensor one of the screws broke off at the head.
Put throttle body in vise, soaked screw with PB Blaster, very carefully applied vise grips for about five minutes with very little rocking. Broke again with only about 3/16" left exposed this time.
So the question, can I apply a little propane heat to it?
While replacing the original throttle position sensor one of the screws broke off at the head.
Put throttle body in vise, soaked screw with PB Blaster, very carefully applied vise grips for about five minutes with very little rocking. Broke again with only about 3/16" left exposed this time.
So the question, can I apply a little propane heat to it?
#4
Thread
Thread Starter
Forum
Replies
Last Post
BRONC-OH
1997 - 2003 F150
1
04-29-2016 12:00 PM
Lowpala
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
19
10-31-2015 01:24 AM
brokeisnojoke
1994.5 - 1997 7.3L Power Stroke Diesel
34
07-25-2011 10:34 AM