Distributor install question...
#1
Distributor install question...
Well, I checked my manual, just says to mark the distributor and rotor, before you take it out. Well, mine is already out, so I need to put it back in. I'm assuming take it to TDC, drop the dizzy in, and line up the rotor with #1? Does anyone have a step-by-step on installing one?
I know it's no biggie, just haven't done one in a LOT of years...
Thanks in advance,
R
I know it's no biggie, just haven't done one in a LOT of years...
Thanks in advance,
R
#2
I have this in my bookmarks, might help you:
http://www.secondchancegarage.com/public/175.cfm
Didn't have time to read through it but I think it is pretty universal.
http://www.secondchancegarage.com/public/175.cfm
Didn't have time to read through it but I think it is pretty universal.
Thread
Thread Starter
Forum
Replies
Last Post
Daddyo's garage
1948 - 1956 F1, F100 & Larger F-Series Trucks
7
06-15-2016 03:29 PM
captain1997
1973 - 1979 F-100 & Larger F-Series Trucks
4
11-15-2014 06:37 PM
ftballman125
335 Series- 5.8/351M, 6.6/400, 351 Cleveland
6
06-09-2005 07:56 PM
289, 38, 400, 78, 96, alignment, distributor, distrutor, flathead, ford, install, installation, installing, v8