While I have your attention you seem to be the resident expert so let me ask you one more question. Where is the STC fitting located? I have searched all over this fourm and can't find the location.
Well I'm looking into possible getting a 6.0, and would like any info I can get as well. I'v been going through the posts on here and really like all the good info from everyone. I love my 7.3 and hate to even think of getting rid of her, but I really do like the ride and overall quality of the 06-07 6.0s and that extra 5th gear doesn't hurt either! Let me know if there are any other things to look out for on these diesels.
Thanks
__________________
1996 F250 PSD Ex-cab 4x4
Dana 50 front axle with Warn locking hubs
Tuff Country 2.5" lift
Autometer Gauges
Banks Stinger-plus system w/Ram Air intake w/NAPA 6637
Banks Trans-command Module
7.3 SD intercooler mod
MAP sensor mod
Well I'm looking into possible getting a 6.0, and would like any info I can get as well. I'v been going through the posts on here and really like all the good info from everyone. I love my 7.3 and hate to even think of getting rid of her, but I really do like the ride and overall quality of the 06-07 6.0s and that extra 5th gear doesn't hurt either! Let me know if there are any other things to look out for on these diesels.
Thanks
Pest007 - need your email address
Robert - Spreadsheets sent
crfpoor - please do not refer to me as the resident expert. I do have a ton of information, but there are so many knowledgeable folks here. Quite a few of them are techs that actually deserve the lable "expert". The STC fitting is on the discharge of the HPOP (high pressure oil pump). The STC fitting connects the hpop to the branch tubes. It is in the "valley" of your engine.
STC / Branch Tube (TSB-08-9-9) - Go to time 35:45 (about) (you will need to paste the address in your browser)
mms://multimedia.ford.com/fordstar/66920.wmv http://www.forddoctorsdts.com/articl...icle-06-10.php
Also - please start a new thread when your question or information is different from the original thread - thanks!
__________________ Mark
06 F250 CC SB ESOF FX4 Lariat 3.73LS 275/65R20; DieselSite Coolant Filter; High Idle Mod; HFCM Plug; Zoodad/Air Fury grill; Accufab Elbow; RACCCV6000 filter; JimmiJammers; Ravelco; SynchroMax in Transfer Case; Fumoto Valve; Harpooned fuel tank; Line-X; CPOhighway Products tool box; tracrac; Fox Weatherboots; Wet Okole Seat Covers; Stanadyne Performance & B2 for lubricity; PIE adapter (thanks Sarge); PIAA 24" wiper blades; updated EGR valve; BriteBox; Re-flashed; Fuel Pressure gauge; DashDaq on deck
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.