ECZ-G Heads and NOS Jahns Pop Top Pistons
#1
ECZ-G Heads and NOS Jahns Pop Top Pistons
I found a set of NOS Jans Racing Pistons, and have a Pr of ECZ-G Heads to build. How much is safe to mill off the head surface during a rebuild? Thx, David
I tried to Post again??? Lets try this...
I found a set of NOS Jans Racing Pistons, and have a Pr of ECZ-G Heads to build. How much is safe to mill off the head surface during a rebuild? Thx, David
I've never encountered tis problem posting? Any Ideas?
I found a set of NOS Jans Racing Pistons, and have a Pr of ECZ-G Heads to build. How much is safe to mill off the head surface during a rebuild? Thx, David
An edit shows my whole post every time, but post doesn't?
I tried to Post again??? Lets try this...
I found a set of NOS Jans Racing Pistons, and have a Pr of ECZ-G Heads to build. How much is safe to mill off the head surface during a rebuild? Thx, David
I've never encountered tis problem posting? Any Ideas?
I found a set of NOS Jans Racing Pistons, and have a Pr of ECZ-G Heads to build. How much is safe to mill off the head surface during a rebuild? Thx, David
An edit shows my whole post every time, but post doesn't?
Last edited by OldSchoolRodz; 06-25-2008 at 10:22 PM. Reason: Hickup in the server, didn't post all of the message
#2
I found a set of NOS Jans Racing Pistons, and have a Pr of ECZ-G Heads to build. How much is safe to mill off the head surface during a rebuild? Thx, David
I tried to Post again??? Lets try this...
I found a set of NOS Jans Racing Pistons, and have a Pr of ECZ-G Heads to build. How much is safe to mill off the head surface during a rebuild? Thx, David
I've never encountered tis problem posting? Any Ideas?
I found a set of NOS Jans Racing Pistons, and have a Pr of ECZ-G Heads to build. How much is safe to mill off the head surface during a rebuild? Thx, David
I cant even get the sentence to post in a reply, Moderator?
I tried to Post again??? Lets try this...
I found a set of NOS Jans Racing Pistons, and have a Pr of ECZ-G Heads to build. How much is safe to mill off the head surface during a rebuild? Thx, David
I've never encountered tis problem posting? Any Ideas?
I found a set of NOS Jans Racing Pistons, and have a Pr of ECZ-G Heads to build. How much is safe to mill off the head surface during a rebuild? Thx, David
I cant even get the sentence to post in a reply, Moderator?
Thread
Thread Starter
Forum
Replies
Last Post
mcmurb
Y-Block V8 (239, 272, 292, 312, 317, 341, 368)
4
11-08-2014 09:55 AM
46yblock
Y-Block V8 (239, 272, 292, 312, 317, 341, 368)
6
02-05-2007 10:09 AM