Replacing oil pump in 302
#1
Replacing oil pump in 302
I have a 1987 302 EFI engine in a Bronco (same year) that recently lost oil pressure. It had been taking longer and longer to come up to pressure lately (the past few months), and finally I went out to start it and had no pressure. So, I need to replace the pump. My Haynes manual says I have to remove the upper intake manifold and take out the radiator to raise the engine up a bit, but I can't see why either of these need to come off? Also, does anybody have any other advice for pulling the oil pan? Thanks.
#2
Thread
Thread Starter
Forum
Replies
Last Post
garsm
1999 - 2003 7.3L Power Stroke Diesel
2
07-31-2011 04:21 PM
SoNic67
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
23
11-17-2010 03:51 PM