What have you done to your truck today?
workin on 2003 F150
Been hearing a crunchin.sound in front jacked up pass side hard to turn so replaced CVJ halfshaft still hard so hub bearing felt loose replaced it too.no noise now but wheel still hard to turn and short axle shaft moves as I turn tire drivers side spins free
.what do you think this could be? Lookin on line and guy has same thing going on says front vacume actuator has truck stuck in 4 by 4 .Anybody got experience on this ? Suggestions needed.Thanks!
.what do you think this could be? Lookin on line and guy has same thing going on says front vacume actuator has truck stuck in 4 by 4 .Anybody got experience on this ? Suggestions needed.Thanks!
Forest you'll get more answers posting in the correct forum.
YOUR FORUM
But having had a 10th Generation F150 4x4 I'll say if it's stuck in 4WD the solenoid that disengages 4WD and holds it in 2WD is probably the culprit.
YOUR FORUM
But having had a 10th Generation F150 4x4 I'll say if it's stuck in 4WD the solenoid that disengages 4WD and holds it in 2WD is probably the culprit.
Join Date: Mar 2015
Location: Merchantville, NJ 08109
Posts: 450
Likes: 0
Received 2 Likes
on
2 Posts
New Motorcraft plug wires, cap & rotor went on today- Then I took her for about a 30-40 mile ride through some of the nice farmland parts of Burlington County... Very enjoyable ride... I was just going with the wind- but made a large circle... I did find one spot where I was going about 30, found a curve, and a speed hump I was not anticipating- I don't even remember a sign there for it! But she rode nicely over it(albeit a bit of a bounce) and all was well... lol... Actually on a street I'd never been on before in Mt Holly area: and I have been on just about every street IN Mt Holly in the past... lol...
Scott
Scott
Join Date: Aug 2007
Location: St. Charles, Missouri.
Posts: 12,183
Likes: 0
Received 14 Likes
on
12 Posts