When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Changed the oil for the first time since getting the truck. Been running low pressure, so I'm trying some rotella 15-40 for a bit to see if pressure comes back up.
jthorngate, I'm going to document everything I do, with photos. This swap has been done to quite a few Broncos, so I know it's doable on a half ton frame like mine.
I'm planning on reinforcing my frame in the areas Centurion should have, and then I'll start on the swap.
Diesel Brad, looks like someone has a nice flatbed in their future!
Today I...
Finally got around to addressing code "67" and the hard, sporadic shifting in my truck. Swapping out the MLPS and connector for the new version and new sensor has, so far, been worthwhile. The truck shifts extremely smooth and does not want to fall out of gear like it once did. Judging by the old MLPS, it was well overdue for a change. Hopefully this will save me from having to buy a new transmission.
Lots of work and nothing to check off on my list. Need new schrader valves for my compression tester. Need bolts to plug the air holes in the heads from the Thermactor. Need a new power steering pulley. Don't ask. Found two frozen bolts on the a/c compressor mount. And on, and on.
Actually, I did get one thing done. Got the first layer of grunge off the engine. Yay Gunk!