8BA flywheel
#1
02-14-2008, 12:17 PM
Join Date: Jul 2006
Location: Estevan, Sask. Canada
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
8BA flywheel
Hi everyone<O
</O
I ordered a pressure plate for my C1BA from Summitr<ST1acing. It was the only one listed for a flathead at Summitr</ST1acing, Jegs and Centerforce Clutches. When it got here, it was too small to fit my flywheel. I don't think my engine was the original one for my truck. The radiator was also larger than the stock radiators installed in F100s. The transition is a 4 speed, may be non synchromesh but I'm not sure. I didn't look at it very much as I'm not reusing it. I believe the engine originally came out of a larger truck, but this is just a guess. Does anyone know if the larger trucks had larger flywheels and if so does anyone carry the pressure plates for them. Thanks in advance.<O</O
Rick<O</O
</OI ordered a pressure plate for my C1BA from Summitr<ST1
acing. It was the only one listed for a flathead at Summitr</ST1acing, Jegs and Centerforce Clutches. When it got here, it was too small to fit my flywheel. I don't think my engine was the original one for my truck. The radiator was also larger than the stock radiators installed in F100s. The transition is a 4 speed, may be non synchromesh but I'm not sure. I didn't look at it very much as I'm not reusing it. I believe the engine originally came out of a larger truck, but this is just a guess. Does anyone know if the larger trucks had larger flywheels and if so does anyone carry the pressure plates for them. Thanks in advance.<O</ORick<O
</O
Last edited by 53 Effie; 02-14-2008 at 12:21 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Snowlover
Explorer, Sport Trac, Mountaineer & Aviator
11
10-28-2014 07:11 AM
