8x6.5 to 8.170mm
#1
8x6.5 to 8.170mm
O.K. I've got a Dana front axle with 8X170mm wheels and a Sterling 10.25 rear with 8X6.5" wheels. How can I make them both match? Anyone know?
I'm hoping that a late 99' and up Sterling rear end hub will swap onto my 1986 sterling hub. But I can't tell, the part numbers are different because of the wheel lug spacing!
Also, didn't they go to the Sterling 10.50" in late 99' when they changed over to the 170mm wheel lug? Are the Sterling 10.25's and 10.50's much different on the out-board side, I'm hoping just the ring gear was the only change. Any help would be appreciated.
I'm hoping that a late 99' and up Sterling rear end hub will swap onto my 1986 sterling hub. But I can't tell, the part numbers are different because of the wheel lug spacing!
Also, didn't they go to the Sterling 10.50" in late 99' when they changed over to the 170mm wheel lug? Are the Sterling 10.25's and 10.50's much different on the out-board side, I'm hoping just the ring gear was the only change. Any help would be appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
cajohnson
1987 - 1996 F150 & Larger F-Series Trucks
10
07-14-2015 01:22 PM
parkerparkerm
1987 - 1996 F150 & Larger F-Series Trucks
4
07-17-2013 07:23 AM
steves_F350_460
1987 - 1996 F150 & Larger F-Series Trucks
0
08-11-2010 02:38 PM
76 4x4 460
Clutch, Transmission, Differential, Axle & Transfer Case
1
07-17-2003 10:52 PM