4.9L Inline 300c.i. performance parts?????
#16
Actually, only one. IIRC AbandonedBronco ran into the same thing at his parts houses in Boise. I have at least one here in Spokane just a few blocks from the house where they stock them individually. I suppose they come in pairs for double pumpers but few of us if any run those on our engines.
#18
Does anyone know where I can get some parts for my 1979 F150 Motor? Its a 4.9, 300c.i. inline 6. Im looking to get rid of the egr carb spacer and replace it with a regular spacer. Has anyone done this yet with maybe an older year spacer with non egr that fits the same? Also what about carburetors? Do they have any aftermarket ones?
#21
#23
Clifford 6=8 intake
Clifford 270 lope cam
Clifford valve springs/lifters/pushrods
Holly 390 cfm 4brl
MSD electronic rev limiter ignition box
MSD plug wires and Blaster coil
Ford dual EFI exhaust manifolds
Walker Y-pipe
just some ideas
Ford Truck Enthusiasts Forums - DillonZ81ford's Album: new engine - Picture
Clifford 270 lope cam
Clifford valve springs/lifters/pushrods
Holly 390 cfm 4brl
MSD electronic rev limiter ignition box
MSD plug wires and Blaster coil
Ford dual EFI exhaust manifolds
Walker Y-pipe
just some ideas
Ford Truck Enthusiasts Forums - DillonZ81ford's Album: new engine - Picture
Thread
Thread Starter
Forum
Replies
Last Post
vanvet
New Member Introductions
1
04-16-2016 07:04 PM
Spktyr
WTB - Parts & other
0
02-27-2016 10:14 AM
300ci Legend
Ford Inline Six, 200, 250, 4.9L / 300
29
02-12-2016 05:54 PM
rebocardo
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
26
01-05-2016 09:25 AM
Tibbetsni
Clutch, Transmission, Differential, Axle & Transfer Case
4
10-15-2011 01:49 PM