Hey guys its been a while. Had to go without internet most of the summer to cut down on bills.
Well heres the update. my 64 f-100 stepside truck now runs and moves uder its own power. Finally got the right clutch tracked down and put in.
I'm still lookin for some parts that i wont have to sell one of my kidneys to buy.
I'm still needin a bottom valence and I'd like a crome grille. Need different steps for the bed. I'd like to find a hole bed reasonably priced. THere is quite a lot of bond on one of the bed fenders that is cracked. How do I go about removing the old bondo and puttin in new?
I'm also needing a steering colum that is a 3 speed. someone put a floor shifter in my truck and i dont like it. For one reason its cheap and they just cut a big hole in the floor. I'd like to put her back on the collum.,
Well I just wanted to give you all a update.
Talk to ya later
do you happen to know the name of the junkyard? I went to a juckyard between Bradford and Newport and they had lots of trucks but no steering collums.
I dont even know how to pull one. Had one guy tell me that I could just unhook everything that is in the engine compartment and then unscrew the plates that are in the floorboard around the collum and pull the hole thing out without haveing to remove the sterring wheel. Can this be done?
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.