I am far from a body man.... I just got a set of OE 4X4 OFF ROAD decals for my F350.... Is there any special way to install these?? any tips so I dont mess them up??
I've installed graphic kits on my dirt bikes. One of the most popular tricks is to start with a clean surface then spray some windex on the area that the sticker is going to be applied. This way you can still move the sticker around if it's not centered properly. Then use a credit card to push out the windex and air from beneth the sticker. You may also try searching the net for some tips. Good luck.
i just sat here and wrote out a nice explaination to this, only to have fte forums not post it... f-in site is making me mad today. anywaaaaaaaaaaays...
windex or a drop of dawn in a spray bottle of h20.
peel off backing and spray decal lightly.
spray the clean area of the bed and align it.
when all lined up, smooth out all bubbles, wrinkles, etc. w/ credit card.
peel off clear piece that's on the printed side.
repeat as neccessary.
__________________
Wisconsin FTE Chapter - Club SNL Member #8
'99 F-250 LD XLT, SC, 4x4 with 5.4L and 3.73
Leave the bowties for the little boys... Ford Trucks all the way!!!
Quote:
Originally Posted by FarmForward
You gotta wonder if this guy's parents saw each other across the table at a young age...
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.
