I have a 55 f100. I was wandering where i could find rear turnsignals that fit inside the bed rails. I have a rolled rear pan and i wanted to mount the turnsignals in the bed rail. If someone can reply I would be very happy. Thanks!

 

If your talking about the little red jewel lights that mount in the bed roll you can get them from mid fifty (midfifty.com, part # 0228-RN $$$. I wouldnt rely on these lights alone for turn signals, they are quite small and may not be legal in some states (must meet a minimum square inch requirement).

I made a set of these lights that I will use as additional brake lights on my truck. Went to the hardware store and bought 2 chrome 1 1/4" sink plugs, drilled the plugs out to accept a jeweled light I found at a swap meet. Total cost about $15.00.

Good Luck

 

I agree that this application may not put out enough light to be effective, however, you may want to check out the aftermarket lights available for motorcycles. I have a JP Cycles catalog that shows several pages of different lights.

 

Hey, thanks so much, for the help and advice. Im pretty young and don't have to much experience under my belt. Thanks again!