Just would like to know if they make a kit of some kind to put a 289 motor in a 48 F1 truck. The motor is out of a 84 ford fairlane and I was going to us the auto trans also. Do they make a kit to where I can weld the motor mounts in so the motor will set straight in the truck. And can I us my original drive shaft also. I just hate to see a good 289 go to waste. he is going to take it out and make a Thunderbolt clone out of his 64. He said I could use the 289 and the auto trans for my truck if I wanted it. Where can I find or get the thinks I need to put the 289 auto in my truck,. Thanks Scott

 

Sure I just posted a thread on installing a 302 today. Check my pics in my gallery.

 

I'm sure there must be a after market motor mount for the 289, should be the same as a 302.The mount would not be to difficult to fab. As far as the drive shaft, more than likely it will need to modified to fit.
Check midfifty for mounts

 

chassis engineering is where I got mine.
http://www.chassisengineeringinc.com/index.html