Gettin' ready to change oil & filter on '06 Ranger w/2.3 Liter, and was wondering if someone could tell me what size wrench/socket I would need to remove oil drain plug? Thanks in advance for any help!!!

 

Same here but I want to know for a 2005 4.0L. I'm too old to climb under and check. Sucks to get old.

 

I belive my 96' is a 15mm.

 

my dads 06 2.3 needed a 14 mm

 

Mine is a 13mm on a 2007 Ranger with 2.3L

 

my 97 is 15 mm also. hope this is helpful to someone

 

I have 6 registered vehicles on the road and am also responsible for maintenance on my daughter's car. (that doesn't count my tractor, my ATV, my snowmobiles, snowblowers and lawn mowers) I'm also a senior citizen so getting up and down off the ground isn't as easy for me as it once was. With so many vehicles I can't remember from one service to the next which tools to take for which vehicles. The solution was quite simple for me, I just take a hand full of sockets with me.

 

2000 4.0 ohv in my truck takes a 13mm.