Ok fuel is gushing out from under the FFA. Has anyone had this problem before, and if so how do you remove the FFA?


Thanks in advance

 

PM me with your email address and I will send you a loooooong MSWord document with everything I have on it. Oh - you do have access to MSWord, right? If not I will turn it into a text file.

 

got it out!........... there is hole at the bottom of the can, what the hell? why does this happen, you think International can make something better. Any ideas on a replacement?

 

use some jb weld.many have used it to repair theirs. i did see one a few days back on ebay for 30 bucks.

 

I just went thru this two or three weeks ago. You can fix with J B Weld. Let it cure the 12-15 hours per directions before putting it back together. My truck is running fine now.

 

Definitely try to patch it first. A replacement bowl is in the "stupid expensive" catagory.

 

well, I was going to try that, but I started to chip my 1/8" hole and it was corroded and it turned into an 1/2" hole. Has anyone taken the black plastic tube from the bowl, I bought an crow's feet wrench but wasn't able to. Tomorrow I'll be looking for a replacement bowl. The stealership want $400 for it. Too rich for my taste. If anyone know where to get one for a reasonable price please let me know.


Thanks

 

could try the junk yards or powerstrokeshop.com ive got 2 tubes of jb on mine. the custom fuel system going in, in a couple weeks ran me about $550 for everything

 

I just worked on mine last weekend. The black plastic tube is a left handed thread so turn it lke you would tightening a normal bolt. Good luck

 

I have seen three or four sell on eBay in the last two weeks for around 50 bucks.