Hello guys i am a new member on this board.

I have been looking to upgrade to some nice long tube headers and was wondering if anybody has or is running these Belanger long tube headers.
I ran across them on this page :http://www.premiertruckaccessories.c...lightning.html

Has any body used these headers and if not what is everybody using??

 

...Welcome to Ford Truck Enthusiasts! Please read the Guidelines, it will help you to navigate through and understand this site.
Stick around someone will be by shortly to answer your question.
We are happy you have chosen the best source for Fords!

Enjoy FTE....and
JOIN CLUB FTE -SUPPORT THE FORUMS!
…..See you on the boards.

 

The Dynatech headers are S. S. and come with cat's. I installed theses on my truck and they are great and the same price.

 

I may have to check those out.

What kinda power gains did you get?

 

I use dynatechlong tube headers and converters, on my 2004 ford lighting that dyno at 400 horse at the rear wheels and 450 pounds of torgue,that good.because you loose twenty percent of your horse from your fly wheel back ,so going with that, I maked 480 horse at the fly wheel,so that good becase a stock makes 380 horse at the fly wheel.

 

Ray, what else have you done to your truck?

 

GRANATELI MASS AIR SENOR 92MM,FLOWMASTER MUFFERS,BOOST BYPASS KIT,180 THERMOSTAT,BIGGER HEAT EXCHANGER,C-L TRUE FLOW INTAKE,C -L TRUEFLOW INLET PIPE,ACCUFAD 1696 CFN THROTTLE BODY,MOTOBLUE BLOWER PULLEY 12LDS. BOOST,COMPETITION ENGINEERING SLIDE-A-LINK TRACTION BARS,NITTO555R DRAG RADIAL,BUY THE WAY ,i HAVE A NEW SET OF SLIDE-A-LINK TRACTION BARS FOR SELL. i ran 160 60 foot times with the tirea and traction bars,that good