Was it worth it?
#1
Was it worth it?
Hi I got a free intake and carb for my 390. the intake is a "edlebrock performer 390" and it has a holly carb of unknown size and i have no clue if it works.
is this intake any good? would it work for what i'm planning on doing with my engine, (bore it out 0.30. a better cam, i'd like to get some good power out of this engine as its going in a 75 F 250 4x4) i'm getting a head of my self. is there any possibility there could be anything wrong with this manifold? like cracks or warpage?
is this intake any good? would it work for what i'm planning on doing with my engine, (bore it out 0.30. a better cam, i'd like to get some good power out of this engine as its going in a 75 F 250 4x4) i'm getting a head of my self. is there any possibility there could be anything wrong with this manifold? like cracks or warpage?
#2
#4
The Performer 390 is the same as the Performer (so I've been told on this site). It's basically the same thing as the stock 4bbl intake except much lighter.
I used a Performer 390 on my 390 build and it ran up to 6000RPM, with a noticable drop-off after 5000RPM or so.
People on here recommend the Edel RPM for high-revving builds, but it's perfect for a motor that won't see above 5000 too much.
NICE!
I used a Performer 390 on my 390 build and it ran up to 6000RPM, with a noticable drop-off after 5000RPM or so.
People on here recommend the Edel RPM for high-revving builds, but it's perfect for a motor that won't see above 5000 too much.
NICE!
#5
#7
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Martin Torres
1973 - 1979 F-100 & Larger F-Series Trucks
7
09-02-2016 11:56 PM
Rogue_Wulff
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
23
06-16-2011 10:23 AM