Does anyone make repo door shells for a 53?
#2
As far as I know they only make the inner and outer lower patch panels which covers about 9-11" up from the door bottom, normally the area rusted out. Do you need more than that? If so you will probably have to look for a good used set. Bob's F100 and Midfifty sell some used parts but I have no idea of the prices. 56FUN
#4
Nixer,
Mid50's sells them also for $475 a door. They are going to have some at Knoxville. Unless a guy just has an absolutely perfect set or could do the work himself and had the time these shells I think are the way from a time and cost standpoint. I saw the prototypes in September at the Charlotte autofair on a 54' F100 display truck that Dennis Carpenter had at his tent.
Mid50's sells them also for $475 a door. They are going to have some at Knoxville. Unless a guy just has an absolutely perfect set or could do the work himself and had the time these shells I think are the way from a time and cost standpoint. I saw the prototypes in September at the Charlotte autofair on a 54' F100 display truck that Dennis Carpenter had at his tent.
Thread
Thread Starter
Forum
Replies
Last Post
punkrockpilot
Bed Covers, Tonneau covers, Toppers/Canopies & Bed liners
1
02-08-2013 03:14 PM