2.8/4.0 bell housing bolt pattern
#1
2.8/4.0 bell housing bolt pattern
I've read that the bolt pattern on the bell housing end of the 2.8L V6 and the 4.0L V6 are the same.
Does any one know where I could find a dimensioned drawing of the bell housing bolt pattern for these engines??
I'm building a Franken-car, and I will have to build my own adapter to go between the engine and trans, and having a drawing would make life easier.
Piper106
Does any one know where I could find a dimensioned drawing of the bell housing bolt pattern for these engines??
I'm building a Franken-car, and I will have to build my own adapter to go between the engine and trans, and having a drawing would make life easier.
Piper106
#3
#4
http://www.babcox.com/editorial/ar/ar40123.htm has a story that might help you.
The page title is:
Rebuilding The Ford 4.0L Pushrod V6, Doug Anderson, Automotive Rebuilder, April 2001
The page title is:
Rebuilding The Ford 4.0L Pushrod V6, Doug Anderson, Automotive Rebuilder, April 2001
Thread
Thread Starter
Forum
Replies
Last Post
BlueOval460
6.0L Power Stroke Diesel
10
01-27-2021 02:58 PM
RotGrubestier44
3.8 & 4.2L V6
1
02-22-2011 03:20 PM
Marco Venegas
Y-Block V8 (239, 272, 292, 312, 317, 341, 368)
5
04-14-2009 12:10 AM