disappointing Extang RT Tonneu Cover
#1
disappointing Extang RT Tonneu Cover
Disappointed in my new EXtang RT Tonneu Cover. Installed it last night the 1st thing I noticed is the rails sit croocked on the truck bed when tightened down. I even put in those spacer strips and it still is crooked makes it very hard to fasten the cover.
I also could not get the cover installed with the bed liner tailgate guard. It would push up against the cover seal and cause it to be bowed.
Right now very unhappy, I am going to try adjusting it this evening (didn't have time last night). Any suggestion or helpful hints in what I am doing wrong?
I also could not get the cover installed with the bed liner tailgate guard. It would push up against the cover seal and cause it to be bowed.
Right now very unhappy, I am going to try adjusting it this evening (didn't have time last night). Any suggestion or helpful hints in what I am doing wrong?
#4
#5
#6
i just put on a extang platimum cover and love it. it went on fast and simple. the rails are tight and straight. the directions said to snap the rear on before the sides. i started doing it the other way and had problems. my wife read the instructions and i did it their way, much easier. even with a serious rain the bed stayed dry.
john
john
Thread
Thread Starter
Forum
Replies
Last Post
nivram
Aftermarket Products
12
06-13-2007 03:25 PM
Cobra330
Bed Covers, Tonneau covers, Toppers/Canopies & Bed liners
3
01-19-2006 02:33 PM
Bernie Lomax
1999 to 2016 Super Duty
2
08-09-2005 11:47 PM