I am just waiting on a address or FYI Jeff I will be passing by Spg some time on Sat around noon ish. I will be coming down 13 Hwy to I-44 and heading west bound.

I can meet you like last time in the wally world parking lot and do a parts hand off, like last time.

 

Afternoon All!

So far, so good. I got a set of rear hatch support struts swapped out this morning, got the Mustang prepped and the base coat shot, and Carina is back from the doctors. After the base coat cures, I can tape out the graphics, shoot them, then lay the clear down. While I'm waiting for the base coat to cure, I'm gonna go pick up that crush car. I hope to be home relaxing around 1900.

 

RC it was all of them the ones to the block were bout to fall out the big one 2 turns . Got a 250 gallon compressor tank today gonna build a new smoker .

 

Good evening all, finally got a deal nailed down on a 1920ish Duncan Fife sofa, all goes well tomorrow,it'll be in our great room tomorrow evening. I've been busy cleaning and organizing the shop. We still got a vacationer in our midst I see. Have a great evening all.

 

Good morning everybody.. I made it to Buddys Salvage in Springfield. They have 3 dents and most were really stripped down pretty hard. A friend of mine and me went to get a few parts and just see what they had as we had not been there in a while. I did not find anything I really needed or wanted but did stock up on a few nuts, bolts and clips.

 

Good Morning Everybody!

Well, the afternoon was a bit more of a struggle yesterday. I didn't get back to the shop from Branson until 1800. I got the rest of the Mustang done and left the shop around 2300. I still haven't even dropped the trailer yet.

I'm just sitting in the recliner drinking coffee, reveling in the knowledge I don't have to go back to the shop until Monday morning!

 

Morning all! Rich I'll pm you. Have to go pick up the tires for the truck today in Branson.

Hope to be back in time for the car show

 

Morning youins!!!!

 

Morning folks...Jeff I will try to get it in the mail today, but if not then Monday for sure.

 

good morning missouri..... still on vacation here.. almost wish i was back at work.. i feel useless sitting here

 

It's beautiful weather outside to be cutting wood! Too bad I have other obligations today. My birthday/Christmas present(MS362) is sitting in the garage just begging me to fire it up!

 

RC...looks like we will have the shifter by the time you get back.

Shifter
New fuel tank
Tank hose
Tank vent hose
Got 2 of the 4 tires from guy in Branson today.


Anything else come to mind?

 

Carpet now purchased for Bullet.

 

Evening All!

Not much happened today. We didn't make the car show. We probably won't tomorrow either. The cold snap has me hobbling around again. It's kinda nice to be able to waste the day once in a while.

 

Howdy all, two more truckloads of wood are split and stacked, coral colored sofa and not sure of color loveseat are in the great room. Jerrycans and mounting bracket are safe in the shop along with my Japanese Corvette.