Hi! Can anyone tell me the stock steel wheel offsets on say 1974 stock wheels and also what they are on 1964 "innes"?
Long story short, I have a 66 f100 with 74 spindles and disk brakes. Cut half a coil and had it aligned (and rechecked) by a guy that has been doing this for 40+ years. I run 1964 "innes" that came off my old 64, and have to run spacers to clear the calipers. It is perfectly aliened but my tire on the drivers side is wearing way more on the outer edge then any other tires. He said it could be from cornering do to the offset on the rims or running the 74 spindles.??.. Thanks guys!

 

Can't offer a remedy, but pretty much all the oem single wheel designs have about 1/2" of positive offset. This chart should help you figure out exactly what you have. Stu

 

Thanks for the info!