Hi everyone. I'm looking into adding F250 factory fender flares onto my Excursion. I need to make sure the rear flares will fit first. Could one of you be so kind as to take measurements of your rear factory flare along the bottom of the front part? I want to make sure it will not interfere with the rear passenger door on the Excursion. Thank you.

 

Really nobody here has factory flares and a tape measure?

 

Can anyone please help me out with this?

 

Perhaps posting your request in the Excursion forum rather than the Superduty forum will get you the results you want.
I'd post a direct link for you but that doesn't work so well on an iPad.

 

They are 3-3/16 inch Wide, hope this helps

 

Yes sir thank you so much, that was exactly what I was looking for.

 

I'm sorry, I totally misread your original post. I didn't see it was F250 flares you were wanting to add. I thought you were talking about Excursion flares.