My recently purchased f600 dump truck clearly doesn't have the original drivers door. Are there any alternate vin locations I can look for?
I'd like to sell this truck when my project is done and it's going to be a hard sell with the title not matching the door. Thanks.

 

Warranty Plate riveted to the left door face below the latch.

Safety Standard Certification Label glued to the 'B' pillar below the striker plate.

There is a hidden VIN stamped on a frame rail, but I don't know the location on a 'big' truck.

 

Look on the underside of the right frame rail, a foot or so behind the cab.
Chuck

 

Couple stickers on the B pillar but neither has a vin. I'll have to get under the truck with a wire brush this weekend when I have more time. Thanks.

 

Here's the label w/a sample of the 11 digit VIN

 

It appears like someone has deliberately tried to hide the original vin for some reason. I can't find that warranty tag anywhere on the truck.
The location of the vin on the frame that was suggested has a weld that serves no purpose streaked along the frame. Looks like someone just ran a stick welder over the vin to destroy it.

 

The Safety Standard Certification Label is composed of an outer clear layer, the inner layer has the printed info.

It was glued to the B pillar. When it got wet, the outer layer could peel off...taking some/all of the inner layer along with it.

 

This is all I've got on the B pillar

 

FWIW: My '58 F600 has the VIN stamped in the top side of the right frame rail directly above the front axle.

 

Who did you buy it from and what does the title say?

 

THANK YOU. It took some elbow grease but I found a vin there, and it matches my title. A few of the #'s are half gone but at least I know I didn't get a bad title.

Excellent!

 

 

Were exactly did you find the stamping? I have the same issue on a 73 F800.

 

Right where awhtx said his was, top of the right frame rail above the front end. Wasn't visible at first. I sprayed the area with wd 40 and noticed a few letter shaped spots getting darker. Then took a wire brush to it.

 

What brand dump bed is that? I want one for my 79.