Hello All,

I've been slowly getting my F100 back to everyday driver quality and I have gotten everything done but the shifting for the truck. It has the top loader 3spd in it with a conversion kit to make it a floor shifter. I have aquired everything to make the change back to column minus the linkages from column to transmission.

I was wondering if anyone on here had extra linkages they could possibly trade or sell. Another option is if someone could provide all the dimensions for each rod I have access to a shop that can reproduce them.

Any help would be appreciated thanks.

 

Please tell us where you are. One of us might be right next door.
Eric

 

Sorry, located in Ohio around the Dayton area but I'd be willing to pay for shipping the parts if needed.

 

Nice truck.

 

Upper pic...at left...showing the two shift rods from the trans to the two selector levers (7302/7303) on the column.

Lower picture: Steering column showing the 3 speeds two manual control selector levers.

See next post.

 

1965/66 F100/250 2WD with 3 speed transmission.

Upper pic: See parts catalog specs for C5TZ-7326-B 2nd/3rd shift rod.

Lower pic: See parts catalog specs for C5TZ-7328-C 1st/reverse shift rod.

Also see post #5.

 

Thanks Numberdummy, I was hoping someone had a set so I didn't have to worry about making them from scratch or the full measurements for the angles and locations of the bends but I may be able to get them made off of the provided descriptions.

 

DBS, how soon are you planning on moving forward with this plan to go back to the column shift? I have this set up in my truck currently and will be moving away from it at some point in the near future. If you have some time I may be able to help you out with the parts you need. PM me if you'd like to discuss.

 

Hey ID Scrounger, I tried to send you a PM in regards to the parts but the forum says you are set to not allow PM's or not allowed to. I would be more than willing to discuss it with you if I could send the message.

 

Dang, I'm still too new to have PM privileges, 6 days to go. Would I get ring up by admin if I posted an email address? I'd also hate to have this one keep bumping up to the top with our banter.

 

If a mod doesn't answer by tomorrow I'll either plan on waiting the six days to PM you or just bite the bullet and post my email.