Dana 60 steering arm question
#1
Dana 60 steering arm question
I have a front Dana 60 on my 79 F250 that was partially taken apart when I purchased it. The 4 nuts that hold the steering arm down are missing (I believe they are 1/2-20 nuts). My question is are there special cone washers that go under these nuts? The steering arm has tapered countersunk holes which makes me think there are tapered washers in there. Also, can anyone link me an exploded view of a 78-79 dana 60 front? Thanks for any help.
#2
The steering arm nuts are special tapered nuts. Here are some links that may help.
Pirate4x4.Com - Extreme Four Wheel Drive
BillaVista.com-Dana 60 Front Axle Bible Tech Article by BillaVista
Pirate4x4.Com - Extreme Four Wheel Drive
BillaVista.com-Dana 60 Front Axle Bible Tech Article by BillaVista
Thread
Thread Starter
Forum
Replies
Last Post
Obowersox26
1973 - 1979 F-100 & Larger F-Series Trucks
4
09-17-2015 06:55 AM
mizsignals
1973 - 1979 F-100 & Larger F-Series Trucks
2
10-26-2011 02:48 PM
Fordbronco69
Clutch, Transmission, Differential, Axle & Transfer Case
18
06-16-2005 08:22 PM