Hello,

Does any one know where I could get a diagram and/or list of all the joints that need greasing under my vehicle? I just got the Gun and the Grease. It is well needed. I looked around for a while under there and found some of the joints. Should I clean the Black Goo out and put the new grease in?

Any positive advice is greatly appreciated!

Thank you,

Matthew

 

All ball joints, inner/outer tie rods and u-joints.
When greasing don't pump it till the grease blows out. Only till you see the dust boots start to move.

 

What Mike said. Also I wipe off the end of the grease nipple before pumping grease in to help keep as much dirt out as possible