HI, I am new to the forum and I have a 1995 f150 extended cab. It has dual tanks and I replaced the filler neck for the mid ship tank. The problem is It wont take fuel like it should. I am wondering if I need to trim the hose back. I feel it might get kinked where the outside hose turns into the tank, its at a 90 deg. any help would be help full, and it is an oem filler neck.
Thanks again and I am looking forward to enjoy the rest of the forum.

 

Welcome to the site.
Sounds like the vent hose is off the tube at the top.

 

When I replaced the filler neck I did it with the tank in place, I removed the old one from the outside hose that is attached to the tank and reinstalled the new one. So I am thinking the small filler hose is kinked.

Thanks for the reply.

 

STILL LOOKING FOR ANY HELP OR SUGGESTIONS ON THE REPLACEMENT OF A FILLER NECK FOR A MID SHIP TANK 1995 F150.
Thanks