You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
this is where i found it after tearing out the 302 efi to put in a 351 windsor
with carb
found the plug was out and laying on the fender.
thanks for the replys but didn't see them before i took out the motor.
am going to sell the efi system.
map sensor for 84 f-150 4x4 w/ 300-6 is just to the rear of the starter solenoid...little black "box" about 3"x 2" with a plug in the bottom and about 4-6 wires on the plug...almost all of my wiring will be going BYE-BYE very soon, so i can simplify my truck...hate all the wiring/vaccume BS that comes on the 80's fords...
MontanaFord
__________________
1992 F-150: X-cab, short bed, 300-6, 5 spd manual, 114000 miles at time of purchase...gonna git shined up nice...
1982 Full-size Bronco: 300-6, 4 spd manual, 9" rear...gonna git some mods done soon...
Member: High Plains Drifters
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.
locating map sensor 86 f150
