Here it is, hope the other side is solid, if not let me know!


Thanks,
reamer

 

How do you DO that?? Great work!

 

That is outstanding work, reamer.

 

Wow, that looks great. What panels do you make and for what years of trucks?

 

That looks great! How about door skins for 53 - 56 panel Rear doors.

 

Craftsmanship of this level is always a pleasure to see. Your work always seems to hit the mark.

 

Very, very, nicely made!!!

 

Used my '48 F-5 as a model. I tried every vendor-supplied cab corner on the market...not one fit or was even close to the factor bends...
So using my drafting skills (and my 30 ton press) I drew up plans for my brother (machinist) to cut me some dies..
I do the cab corners, and front fender-to-running board patches.

 

Well done good sir!

 

Very nice work!

 

Looking good. When you make them for a 55, let me know.

 

Wow. Just like the big boys. How about a photo of the dies?

 

Reamer I will be needing some for my 48 F1. I also need the front fender to running board patches. Can anyone tell me if the Coe lower Fender patch is the same. I will need 4 for the Coes years 48 and 51. Great living on the rusty east coast.

 

I believe they are the same. Ford mentality, why make two styles of the same thing

 

Sure wish I could get a hold of a pair of nice cab corners!