should I replace the sensor while I have it out or can I just clean it?

 

No problem! Lists what?? abbreviations?

 

Imo depends on how dirty and clogged it is. if its really clogged you can try to clean it just be verrrryy careful there is a screen at the middle on the sensor that you cant break. Or if you dont want to do that you can use buy a new one, id get motorcraft- not sure how much it is.

 

yes the abbreviations. when I was on the obs forums I had them down pretty well. but there more complicated and more of them here.

 

Riffraff (Clay) sells international bellowed up pipes, he dosent make them, well he used to make a lot for the E99 but not sure if he is still doing that.

There is absoluty nothing wrong with the bellowed Dormans. The last set I got had great welds,fit perfectly and where $300 cheaper than the international.

 

Getting ready to go pull exhaust back pressure sensor. If the tube is clogged what is the best way to clean it? Brake parts cleaner? Degreaser?

 

A piece of weed wacker string in a drill augers it out pretty well.

 

I figured it would need something to dissolve the soot

 

You have the best truck on the road and the one most likely to be stolen. I know from experience. THe first thing I did when I drove home my replacement truck was buy The Club. Plan to add an alarm and/or immobilizer.

 

took the faring off the back of the cab. i think it looks better and got rid of an annoying rattle