F7 and F8 fenders
#1
F7 and F8 fenders
I know most of the big trucks were scrapped that had the F7 and F8 fenders. The same the Coe uses. I recently looked at fenders that were not dented but so paper thin that sand blasting would of destroyed them. I was wondering how feasible it would be to fiberglass over them to try and make a mold to create new fiberglass fenders for the Coes and big trucks. Any thoughts on this guys.
#2
#4
#5
#6
You heard incorrect. Conventional fenders, regardless of series have the same general shape. The F7-8's are just a little wider. Length and shape is the same. COE fenders have a decidedly different shape on the rear half.
Big Job F-7/8
COE
"typical" conventional
The 48/50 COE grille and F7/8 grille is wider than the F1/6 trucks. The grilles are all the same for 51-2.
wide grille
narrow grille
Big Job F-7/8
COE
"typical" conventional
The 48/50 COE grille and F7/8 grille is wider than the F1/6 trucks. The grilles are all the same for 51-2.
wide grille
narrow grille
#7
Trending Topics
#8
I know most of the big trucks were scrapped that had the F7 and F8 fenders. The same the Coe uses. I recently looked at fenders that were not dented but so paper thin that sand blasting would of destroyed them. I was wondering how feasible it would be to fiberglass over them to try and make a mold to create new fiberglass fenders for the Coes and big trucks. Any thoughts on this guys.
#10
Gee, replying to an old post here! So your picture shows a COE, 51. I assume that is what your asking for fenders for? Keep in mind, as said here, COE and regular cabs are different, and 48-50 is different than 51-52. and F1 has smallest wheel opening, than F2-F6 is bigger wheel opening but same width, than F7 & F8 is wider. I happen to have 48-50 F8 regular cab fenders.
#11
A guy in St. Louis has a set of NOS 51/52 F-7/8 fenders for sale. I bought a 1947 fender from him last week. Stu
https://stlouis.craigslist.org/pts/d...301388876.html
https://stlouis.craigslist.org/pts/d...301388876.html
#13
Fab if I have to
Gee, replying to an old post here! So your picture shows a COE, 51. I assume that is what your asking for fenders for? Keep in mind, as said here, COE and regular cabs are different, and 48-50 is different than 51-52. and F1 has smallest wheel opening, than F2-F6 is bigger wheel opening but same width, than F7 & F8 is wider. I happen to have 48-50 F8 regular cab fenders.
#14
wanted : 1952 Ford F7 front pass side fender and hood Close to Sacramento California
I am looking for a 1952 Ford F7 right front fender in the Sacramento Calif area .I'm willing drive a distance to get it . Anything out there ? It's for an old Fire Engine ...Larry vagabond88@sbcglobal.net