Bronco II carb rebuild
#1
Bronco II carb rebuild
I first posted this under the carburetor section, but there doesn't seem to be much traffic there so I am posting it here....thanks in advance if you can help me at all.
I'm rebuilding my first carb, and it's an old motorcraft 2150 carb my uncle gave me so I was tearing it apart and noticed I am missing something on the bottom down by the throttle plate. It looks to me like it is the bottom of one of the venturi assembly holes(maybe an air bleed or something). But I have no idea what it does, nor do I know how to re-install something in there if I need to. Would anybody be able to help me out? Attached is a picture with an arrow pointing to my concern, thank you very much for your time!
P.S. If it matters, I am rebuilding the carb to put on my 1985 bronco ii. Once I have the carb ready I am planning on doing the duraspark conversion.
Thanks again!
I'm rebuilding my first carb, and it's an old motorcraft 2150 carb my uncle gave me so I was tearing it apart and noticed I am missing something on the bottom down by the throttle plate. It looks to me like it is the bottom of one of the venturi assembly holes(maybe an air bleed or something). But I have no idea what it does, nor do I know how to re-install something in there if I need to. Would anybody be able to help me out? Attached is a picture with an arrow pointing to my concern, thank you very much for your time!
P.S. If it matters, I am rebuilding the carb to put on my 1985 bronco ii. Once I have the carb ready I am planning on doing the duraspark conversion.
Thanks again!
#3
#4
Thread
Thread Starter
Forum
Replies
Last Post
|WYG|SS
Ford Inline Six, 200, 250, 4.9L / 300
5
02-07-2013 10:14 PM