Guy's I bought a used truck and I am pretty sure the rear driveshaft is too short,so can anyone give me a measurement for rear driveline on a 1994 F 350 4x4,5 speed manual tranny,long bed,single cab,with a 460 engine.It has 1 piece driveline with a slip yoke that go's into the tranny.slip yoke only will go in about 3 inch's onto the spline's and I can make it move up and down slightly with my hand.Truck has some vibration when driving.

 

Back to first page.

Hopefully someone can help you out.

 

Got it fixed.

 

Aaaaand the problem was.....
What was the fix.

It's always good to put a solution that way when someone else searches for a problem similar to yours, that they have a solution.

 

Wrong drive shaft was put in by first owner,it was 4 inch's too short with not enough contact of the slip-yoke on the tranny spline's.