Category: Exterior - Body Parts
Price: $0
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): '92+ Civic/EL & Del Sol
Item Condition: CA
Shipping Information: Item can be shipped
Engine: Part suitable for gas truck

1965 F100 Custom Cab LB, very clean & solid Southern California vehicle. I am parting the entire vehicle with exception of engine and transmission not available. Most sheet metal and chassis is still in original paint with little or no rust or damage. Let me know what you're looking for: gauges, glass, steering, suspension, sheet metal, patch panels, badges, trim, grille, seats... Asking all fair/negotiable prices, not looking for catalog prices. This truck has cool vintage slot type (halo brand-style) mag wheels which would look good on a restoration. Photos on request.
Also available 1966 F250 long bed with some front edge rust damage, driver's door with repair/bondo in center of door skin and tailgate with few dents on top edge. The bed could be repaired or better suited as a donor for repair panels. With the exception of the rusted section, the remainder of the floor is in very good condition with minimal dents or wear.
PM or phone 661-805-5782. So. Cal (bone-dry) Central Valley.
Best and quickest to email me at ehershkowitz@hotmail.com. Be sure an specify '65 f-100 parts in the subject line so your message doesn't get lost.

 

will the tailgate fit on a 64 flareside 2wd?

 

Steve:
The tailgate would be for a "Style Side" (smooth-sided '64-'66). I don't believe that Ford used the term flareside. The black truck in your profile photo is a step-side, and the tailgate would not fit that vehicle. Let me know if you need photos. Thanks!

 

yeah, i was wondering if you had a style side. Actually, "flareside" is the correct term for a ford. "step side" is a chevy term. i was corrected early on by someone on this site. lol.

thanks anyway.

 

I need the 65 grille. PM me or call me at 951-306-7805
I'll also want the 66 grille if both are aluminum.

 

My 66 cab is smashed in behind the driver's door for about 18 inches up and wrapping around the back about 6 inches , been searching for a complete corner off a parts truck for a while . would you be willing to cut off patch panels ?

 

Do you have the badges for the f250 available? What shape are they in?

 

Thanks guys. I have replied to all and forwarded my email address. It's easier to send you photos that way. It was nice talking to you Robert. I'm still looking into the grille options, so thanks for your information.

 

I sent you a PM.

 

Hello. If you're still looking for a grille for your 1965 ford f100, i have one. It is aluminum. Im asking $200 for it. I also have the headlight bezels also aluminum for $80. Thanks

 

any chance you have a stock radio

thanks

 

Yes, I have two. Email me for pic's. I need you to see, as both have pitting in the chrome trim. ehershkowitz@hotmail.com
Be sure and put F100 parts in the subject line.
Thanks,
Eric.

 

Grille, radiator support, badges, radio, grille nameplate are sold. Still have a lot of nice parts remaining but the rust free stuff is going quickly. Except engine and trans, have almost the entire 65 F-100 still parting and a 66 bed for repair or patch panels. Suspension, steering, driveline and rear axle remain. Email me your needs: ehershkowitz@hotmail.com.

 

Do you still have the exterior trim for the 65?

 

Yes, I have the complete set, long bed. Sent you a PM.
Thanks!