Due to not having enough light under the 292 engine i can't see what kind of bolts are holding the seal retainer in place. They look like a head for a 3/8 or 7/16 socket . But a regular socket will not grab them. Is there a special tool i need to remove the retainer ?____JIM

 

If they are made to take a socket, it has to be a 12 point, and I think its a 5/16, some took an allen wrench.

 

Not an allen wrench, that's the kind i have found before . I have a couple of 12 point sockets ordered to pick up later this week at NAPA, but thanks .


.

 

It should be a 3/8" 12 point socket.

 

Great, i just picked up a 12 point 3/8 socket i had on order , find out next trip to the shop.






.