Pulling my hair out re: heater knobs
#1
Pulling my hair out re: heater *****
Long time reader, first time poster.
I'm going crazy trying to figure out how to remove the ***** for the heater controls in my '65 Econoline. There are three *****; the center one is on a "D"-shaped shaft, so that's cake. The outside ones (with bezels labeled "TEMPERATURE CONTROL" & "PULL FOR HEAT") are on round shafts with no visible set screws in the side of the *****.
What am I missing? I know there's some Econoline guru out there with the right answer...
Thanks in advance!
I'm going crazy trying to figure out how to remove the ***** for the heater controls in my '65 Econoline. There are three *****; the center one is on a "D"-shaped shaft, so that's cake. The outside ones (with bezels labeled "TEMPERATURE CONTROL" & "PULL FOR HEAT") are on round shafts with no visible set screws in the side of the *****.
What am I missing? I know there's some Econoline guru out there with the right answer...
Thanks in advance!
#2
#3
Long time reader, first time poster.
I'm going crazy trying to figure out how to remove the ***** for the heater controls in my '65 Econoline. There are three *****; the center one is on a "D"-shaped shaft, so that's cake.
The outside ones (with bezels labeled "TEMPERATURE CONTROL" & "PULL FOR HEAT") are on round shafts with no visible set screws in the side of the *****.
I'm going crazy trying to figure out how to remove the ***** for the heater controls in my '65 Econoline. There are three *****; the center one is on a "D"-shaped shaft, so that's cake.
The outside ones (with bezels labeled "TEMPERATURE CONTROL" & "PULL FOR HEAT") are on round shafts with no visible set screws in the side of the *****.
Thread
Thread Starter
Forum
Replies
Last Post
Goldenvoice
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
3
03-28-2015 06:10 AM
dotcentral
1967 - 1972 F-100 & Larger F-Series Trucks
1
09-17-2014 07:32 AM
The Masked Rider
1961 - 1966 F-100 & Larger F-Series Trucks
5
07-29-2013 05:11 AM