intake pinching headers
#1
intake pinching headers
My 300 intake, An offy dp, is pinching one of my header tubes. I haven't even gotten my heat pipe on yet:l
I can find a picture it's the center right in between the three and 4 cylinders on the intake so I can't grind it down too much.
My headers are already ceramic coated, but will a 2x4 and a bfh take care of that?
I can find a picture it's the center right in between the three and 4 cylinders on the intake so I can't grind it down too much.
My headers are already ceramic coated, but will a 2x4 and a bfh take care of that?
Thread
Thread Starter
Forum
Replies
Last Post
77'Sam
Ford Inline Six, 200, 250, 4.9L / 300
13
01-28-2007 06:53 PM
grappledad
Ford Inline Six, 200, 250, 4.9L / 300
1
09-19-2004 08:18 PM
ExcellentRed
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
15
06-25-2003 11:18 AM