Little Help Quick Question
#1
Little Help Quick Question
Ok so I'm replacing the 4.6 in my 03 explorer at this point motor is sitting in the mounts, transmission is on the dowels all the bolts in the bellhousing finger tight roughly 1/4 to 3/8 gap and still can't locate the torque converter studs am I not close enough messed up gone to far? Please drop some words of advice of possible
#2
The studs are prob pressing against the flywheel and they are turning together. Loosen the trans mount and slide the trans back as far as it will go to get a little more room. You may need to wedge something against the torque converter to keep it from turning while you turn the engine. Once you get it lined up and the trans tight against the engine the torque converter should be able to rock back and forth slightly in the flywheel holes. If it doesn't then something is in a bind.
#4
#5
#6
Thread
Thread Starter
Forum
Replies
Last Post
EvoDawg
Engine Swaps
2
12-05-2009 08:13 PM
THE KING
Clutch, Transmission, Differential, Axle & Transfer Case
5
09-18-2006 03:29 PM
DocMel
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
5
05-15-2006 07:10 AM
smallblock351w
Clutch, Transmission, Differential, Axle & Transfer Case
3
04-02-2006 07:48 AM
kvb78
Clutch, Transmission, Differential, Axle & Transfer Case
4
04-24-2004 10:05 PM