While on the subject and following advice, next year i plan to do some injectors and was hoping for thta 350-400 hp range. Less than 400 for fears of the PMRs, is that still the "threshhold" on the PMRs? What would a 160/30 realistically produce? 350? 375? I think if i can get in the 375 range that would be the cats pajamas..... Would the ww2 support that? Or would need to upgrade turbo?
I've never run a setup with 160/30's but I can tell you that with the setup in my sig for the F-250 I dyno'd 350 hp & 700 torque. The Swamps 175/146 single shots (175 cc with stock nnozzles) are similar to 160's with stock nozzles. When I chose this setup 8 years ago there were many threads on the forums about PMR's & windowed blocks. I didn't want to push this motor too much considering this vehicle's main purpose was to haul the 5th wheel camper & family around the country and a daily driver for work. These "stage 1" style injectors, van turbo, Tony's tuning and supporting mods have been a very reliable setup for me over the years. Even though they seem like small injectors compared to some of the other options out there - they pack a nice punch and make pulling the camper fun & easy. Over the years it seems that tuning has more to do with the PMR scare than an actual HP number. Look at Pocket - He's running some much larger injectors with PMR's - and towing with that as well.
The Excursion (Forged rods) is a different story - with the 160/80's, S366 turbo & Tony's tunes she's gotta be somewhere around 400 or more. It doesn't accelerate like the F-250 - it launches. It weighs allot more than my 2WD F-250 and it's faster. EGT's don't get hot and the seat of the pants power feels much higher. Tony e-mailed me 4 programs - I downloaded them on the hydra chip and didn't have to get any adjustments. He nailed it right on for me. Stock, economy, tow, street, extreme. On the drive home from Denver (650 miles) I was pleasantly surprised to average 16 MPG at 75-78 mph, with 33" tires and a lift.
I would think with 160/30's (and supporting mods) that you would be somewhere north of 350 HP and PMR safe with good tuning. Plus with a healthy HPOP you might not need to upgrade that as well. But the stock turbo will need to be upgraded sooner or later.
You can drain the 160 with a stock nozzle, but only with a pretty long Fuel Injector Pulse Width and high Injector Control Pressure - this makes heat and smoke. The magic numbers are 3000 PSI max and 3 ms max. The more fuel you get in there at WOT under that 3ms max, the cooler the EGTs will be and you will get higher HP - but the higher torque is with a smaller nozzle. I went with a bigger nozzle for lower EGTs at full fueling.
That being said, the AC160/stock can put a lot more fuel in there sooner than the stock split-shots, and give you cooler EGTs while towing or working the truck under "normal" conditions. Stage 1 is a serious upgrade from stock, you will not be disappointed. If your goal is to scream down the road with your hair on fire and shred tires, drivelines, and transmission - the 100% nozzles can get it done.
Noob question: how difficult is it to replace nozzles? Would it be reasonable to have say 160/100s, and if one fails in Peoria grab an off-the-shelf AC from IH and swap nozzles?
I wouldn't even try it. The potential for making a mess is too great for me personally. I bought a 9th injector (flow balanced) for this very reason. Maybe somebody else can share their thoughts on this.
Great post, Toreador_Diesel... but I would amend that tuner list a little. Brian at Brian's Transmission Service has good tunes, I just don't know if he's tuning on the Hydra. I would drop PHP off the list for customer service reasons. Without dwelling long on this - I heard the rumors of poor customer service, and I personally learned they were not just rumors.
As did I when I was looking into their FICM tune and modified tune for my 6.0.
Consider the list amended to include BTS tunes...
__________________ Excursion & 6.7 Forum ModDeath Row Inmate #21 Black Beauty The Mighty 6.0: 2005 Ford Excursion Limited, 4wd "The 6.0" Bulletproofed by Powerstroke Enginuities Straight pipe, Atlas 40, Heavily RiffRaff'd, and Gearheaded Big Red Beast The Mighty Excursion: 2001 Ford Excursion Limited, 2wd, "The 7.3" Built with blood and sweat by Me and Riffraff Diesel, heavily modded, also Gearheaded FTE Guidelines
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.