I think my clutch is going out, when i push the clutch, shift, and let off the clutch pedal comes a little then stops and then either pops on its own or i pull it with my foot. Is it my clutches or something simpler?

 

Found the problem its my slave cylinder, anyone know how to remove it?

 

If you have a lot of miles make sure the bushings in the clutch shaft aren't wore out and that the stub shaft that the master rod attaches to isn't worn badly. My master is good but the rod eye and stub shaft are worn and cause me to have lift the pedal with my toe.

 

I dont think its that when i push the clutch all the way down put the truck in gear i can drive around without letting off the clutch

 

proper clutch adjustment is most important, hydraulic clutch's are not self adjusting, to much free play at lever can make the clutch drag

 

Make sure your firewall isn't tearing as well.