Does anybody make them for pickups? 2014 superduty 250xl. thank you John

 

Usually you purchase dimensional lumber (like a 2x4) and rip it to fit the pocket.

 

I must be getting old.

We simply just dropped a 2x4 into the pocket cut to the length we wanted and nailed it to the side boards.

Never had any idea that anything was "made" for the pocket hole.

 

2.3" by 1.7"according to the Ford document. Not a standard 2 by 4, but a standard 2 by 3 would just need a little bit trimmed off to fit. Strikes me as odd that it's not an off-the-shelf size, but there you go.

Brian