Ran a few tests on the Henry today (AE from Clay).
Dead cold and did the KOEO and all good (Buzz test, sensors etc).
Checked for codes and only had P1211 and that would be the PHP FU2 6 Pos Chip. Also the soft code that throws due to AIH Delete mod (can't think of the number off top of head P03--).
Cleared the codes and P1211 didn't reappear for the rest of the tests.
I left the Chip in during tests but had it set at the lowest (Extra 25HP being closest to stock).
Took her for a good run to get up to full operating temps and ran a KOER test and all good.
All data looked good ICP, pulse widths etc.
Ran a Cylinder Contribution Test and came up with:
The truck is running beautifully with no sign of a miss, smoke etc.
I know that the Gray CPS can throw this as a Phantom Code.
Just wondering if any of you fellas get the same code on our Aussie 7.3 trucks?
__________________ Aussie spec 2005 (US 2003) F-250 SD 4x4 7.3Ltr Powerstroke: PHP FU2 6 Posín Chip,6 x ISSPRO Guages, AIS Intake, Zoodad, Hutch'd ní Harpoon'd. Cowl Hood, AIH Delete, CCV, RiffRaff FRx,HPx,OCR, JWVB. ARB Air Lockers Front & Rear,V10 Tranny cooler + Stock Tranny cooler, ARB Bull Bar. Long Range Fuel Tank,VMS in Dash GPS Nav.OME Suspension & Dual Tower Shocks, MOOG Ball Joints. GVWR (GVM) Upgrade to 5,000Kg (F350+).
I fitted Clay's FRx and that seem to settle the noisy number 8 down some and also fitted the HPx as well , some say this will give you a smoother idle but that's debatable.
I run AE last week and pulled some codes
which are no weal problem as for the AIH delete , i still get a soft code but no biggie , i made up a wire with some resistors in line to stop the soft code , will check it out and let you know.
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Fordģ is a registered trademark of the Ford Motor Company.