5.4 Rear Crank Seal/Oil Slinger
#1
5.4 Rear Crank Seal/Oil Slinger
I'm rebuilding my '99 Expy 5.4 and have a question about the Rear Seal (P/N 6701) and the Oil Slinger (P/N 6310 aka dust guard) WITH a retainer plate. I have the service manual and a Chilton's book...neither of them give any details on how to install these parts. They just say "use the special tools".
I don't have the fancy install tools. When installing the seal, do you drive the seal into the retainer plate so that it is flush with the inside edge of the plate? The slinger/dust guard goes in behind the seal. Should the face of the slinger be flush with the outside edge of the retainer plate or slightly recessed into the retainer plate?
Thank you for your help!
I don't have the fancy install tools. When installing the seal, do you drive the seal into the retainer plate so that it is flush with the inside edge of the plate? The slinger/dust guard goes in behind the seal. Should the face of the slinger be flush with the outside edge of the retainer plate or slightly recessed into the retainer plate?
Thank you for your help!
#2
Thread
Thread Starter
Forum
Replies
Last Post
NCFarmLife
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
9
08-03-2017 02:10 AM
cadunkle
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
5
11-24-2016 02:47 PM
Fat Fendered Ford
1948 - 1956 F1, F100 & Larger F-Series Trucks
1
10-11-2004 11:43 AM